Fujitsu M2694ESA:Switch Settings
PCA Layout All configurations marked * are default settings
SCSI Level Key 1 ON* SCSI-1/CCS Mode OFF SCSI-2 Mode Off-Line Self-Diagnostics Key 2 ON Executed (diagnostic mode) OFF* Inhibited (normal operation) UNIT ATTENTION response Key 3 ON* Reports the CHECK CONDITION status OFF Does not report CHECK CONDITION Reselection Retry Count Key 4 ON* Unlimited OFF 10 times SCSI Bus Parity Key 5 ON* Enabled OFF Disabled Synchronous Data Transfer Request Key 6 ON* Enabled from TARG OFF Disabled from TARG LED Display Requirement Key 7 ON* LED activated when drive seeking OFF LED activated when drive idle Motor Start Mode Key 8 ON* On Power Up OFF Via START/STOP UNIT command
There are no user changeable settings on this terminal. It is for factory use only.
1-2 SHORT* Do not change.
SCSI Terminating Power 3-4 5-6 Function SHORT* SHORT* Power is supplied to the terminating resist or from the IDD and TEMPWR pin. Power is also suppiled to the TERMPWR pin from the IDD. (Pin26 of the interface). OPEN SHORT The TERMPWR pin is not used. Power is supplied to the IDD terminating resistor only from the IDD. SHORT OPEN Power is not supplied to the terminating resistor form the IDD, only from the TERMPWR pin.
Set SCSI ID 5-6 3-4 1-2 ID OPEN* OPEN* OPEN* 0 OPEN OPEN SHORT 1 OPEN SHORT OPEN 2 OPEN SHORT SHORT 3 SHORT OPEN OPEN 4 SHORT OPEN SHORT 5 SHORT SHORT OPEN 6 SHORT SHORT SHORT 7
Write Protection 7-8 SHORT* Disabled OPEN Enabled 9-10 OPEN* Reserved
Spindle synchronisation connection Pin Signal 01 GND IN 02 SPSYNC IN 03 GND OUT 04 SPSYNC OUT
External LED connection Pin Signal 01 LED(V) 02 LED
External SCSI ID connector Pin Signal 01 GND 02 -ID2 (bit 4) 03 GND 04 -ID1 (bit 2) 05 GND 06 -ID0 (bit 1)
to the table of contents!!