Location of setting jumpers
Fujitsu M1636T/M1623T/M1624T/M1638T:Jumper Settings
Figure 1 shows the location of the jumpers to select drive configuration and functions.
Factory default setting
Figure 2 shows the default setting position at the factory.
(1) Device type
Master dedvice (device #0) or slave device (device #1) is selected.
(2) Cable Select(CSEL)
In Cable Select mode, the device can be configured either master device or slave device. For use of Cable Select function, Unique interface cable is needed.
Figure 5 and Figure 6 shows examples of cable selection using unique interface cables.
By connecting the CSEL of the master device to the CSEL Line (conductor) of the cable and connecting it to ground further, the CSEL is set to low level. The device is identified as a master device. At this time, the CSEL of the slave device does not have a conductor. Thus, since the slave device is not connected to the CSEL conductor, the CSEL is set to high level. The device is identified as a slave device.
to the table of contents!!