CFP1080s
Customer Options

SCSI Bus Address
There are three jumpers available for configuration of SCSI ID: ID0, ID1, and ID2. The following table defines the settings:

SCSI Bus Addresses*

(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

ID0ID1ID2SCSI ID
OUTOUTOUT0
INOUTOUT1
OUTINOUT2
ININOUT3
OUTOUTIN4
INOUTIN5
OUTININ6
INININ7

*Use either but not both : J6 or J4.

Disable Spin: A jumper on Disable Spin, disables spin up on power-on and the host adapter must send a Start Unit Command prior to operating the drive. Disabling spin up on application of power can also be enabled by settting the DSPN bit in MODE SELECT page 0.


J4
1+12 V
2Ground
3Ground
4+5V

Mounting Holes
Side: 6-32 UNC-2B .16 Max. Insertion
Bottom: 6-32 UNC-2B .22 Max. Insertion