Customer Options

The CP2084 drive is designed to operate either as a Master drive (C Drive) or a Slave drive (D Drive). This feature is dependent on two drive settings; the status of hardware jumper M/S and the firmware setting of a feature bit. When (M/S) is closed, and the feature bit is set, the drive will assume the role of a Master drive. When (M/S) is open, and the feature bit reset, the drive will act as the Slave. In single drive configurations, M/S must remain in the closed position.

(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

CMOS Drive Parameters
Heads 8
Landing Zone548

Mounting Holes
Side: 3mmx0.5mm THD4x) 4mm Max. Insertion
Bottom: 3mmx0.5 THD (4x) 4mm Max. Insertion