CP2064
Customer Options

The CP2064 is designed to operate as a master (drive C) or as a slave (drive D). This feature is dependent on two settings: Jumper E1 and the firmware setting of a feature bit. If E1 is closed and the feature bit is set, the drive will be the master. If E1 is open, the drive will be the slave. As a single drive, E1 should be closed.


(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

CMOS Drive Parameters
Cylinders 823
Heads 4
Sectors 38
Precomp 0
Landing Zone 823

Mounting Holes
Side: 3mm x 0.5mm THD (4x) 4mm Max. Insertion
Bottom: 3mm x 0.5mm THD (4x) 4mm Max. Insertion