CP2034
Customer Options
The CP2034 is designed to operate as a master (drive C) or as a slave (drive D). This feature is dependent on two settings: Jumper E1 and the firmware setting of a feature bit. If E1 is closed and the feature bit is set, the drive will be the master. If E1 is open, the drive will be the slave. As a single drive, E1 should be closed.
(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)
| CMOS Drive Parameters |
| Cylinders | 411 |
| Heads | 4 |
| Sectors | 38 |
| Precomp | 0 |
| Landing Zone | 411 |
| Mounting Holes |
| Side: 3mmx0.5mm THD4x) 4mm Max. Insertion |
| Bottom: 3mmx0.5 THD (4x) 4mm Max. Insertion |