Customer Options

The C/D jumper is used to determine whether the drive is a master (drive C) or a slave (drive D). The drive is configured as a master, when jumpered, and a slave when not jumpered.
The cable select (CS) jumper is used in systems implementing cable select, in which master or slave is determined by the connector attached to the task file interface.

(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

1 +12V
2 Ground
3 Ground
4 +5V

CMOS Drive Parameters
Cylinders 1238*
Heads 16
Sectors 63
Precomp 0
Landing Zone 1238

* 1024 Cylinders should be entered into the CMOS parameters unless the drive is being used with a device driver, BIOS, or OS capable of supporting extended cylinders or LBA.

Mounting Holes
Side: 6-32 UNC-2B .16 Max. Insertion
Bottom: 6-32 UNC-2B .22 Max. Insertion