Customer Options

The C/D jumper is used to determine whether the drive is a master (drive C) or a slave (drive D). The drive is configured as a master, when jumpered and a slave when not jumpered. The cable select (CS) jumper is used in systems implementing cable select, in which master or slave is determined by the connector attached to the task file interface.

(The table on this page requires NETSCAPE version 1.1 b3 or later to view properly.)

1 +12V
2 Ground
3 Ground
4 +5V

CMOS Drive Parameters
Cylinders 839
Heads 16
Sectors 62
Precomp 0
Landing Zone 839

Mounting Holes
Side: 6-32 UNC-2B .16 MAX. Insertion
Bottom: 6-32 UNC-2B .22 MAX. Insertion