Customer Options

The C/D jumper is used to determine whether the drive is a master (drive C) or a slave (drive D). The drive is configured as a master, when jumpered, and a slave when not jumpered. The ATA/ISA jumper is used when when daisy-chaining two drives. This jumper may have to be removed when this drive is used together with older (Pre-ATA) drives.

(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

J6 J4
1+12 V 1+5 V
2Ground 2+12V
3Ground 3Ground

Mounting Holes
Side: 6-32 UNC-2B .16 Max. Insertion
Bottom: 6-32 UNC-2B .22 Max. Insertion

CMOS Drive Parameters
Landing Zone1572

* 1024 Cylinders should be entered into the CMOS parameters unless the drive is being used with a device driver, BIOS, or OS capable of supporting extended cylinders or LBA.